FTS Installation and System Check-Up Page

• Read all the steps before proceeding using Internet Explorer
  • Step 1: If you see a picture below and the statement "Configuration is Fine", then you are done.

    If you do not see the picture but instead you receive question prompts regarding "do you want to install and run ..." go to 4. below.

    If you do not see the picture and you do not get question prompts, check you have set up Internet Explorer for downloading Active X controls.  To do this in Internet Explorer click on Tools, Internet Options and Security. Click on the button labeled Custom Level.  Check the following boxes are checked:

    1.  Download signed Active X Controls (check Enable or Prompt)

    2.  Download unsigned Active X controls (check beside Prompt)

    3.  Run Active X Controls and Plug-ins (check beside Enable)

    4.  If you have to retry Automatic Installation:  After you close this screen restart the installation process from the FTS Login Form (www.ftsnet.com or www.ftsmodules.com).  Now you may get a bunch of question Prompts regarding "Do you want to install and run .." accept each one by clicking on Yes. The screenshot may appear as follows (the precise names will depend upon what is not on your system). To see click on screen If the picture appears go to step 2 otherwise continue with the next bullet.

    You will see the picture below once you have successfully completed the automatic installation using Internet Explorer.  If you do not see the picture, you should complete the alternative installation procedure by clicking on here now.  

  • Once completed close this window and now you are ready to use the FTS System.